TM10-3930-660-34 16-12.1. INNER BOOM - REPLACE/REPAIR (Cont’d) 14.        INSTALL    FOUR    BOOM    ELECTRICAL    CABLE CLAMP ASSEMBLIES (PARTS 21-24) TO BOOM ELECTRICAL CABLE (25). a.  Apply Loctite 242 to capscrews (21). b.      While   pulling   cable   (25)   tight,      install   clamp halves    (24),        spacer    plate    (23),        and    two capscrews    (21)    to    outer    boom,        closest    to tensioner (20). c.  Install remaining three cable clamps while pulling cable (25) tight. 15.  CONNECT  BOOM  ELECTRICAL  CABLE  (25)   TO SOCKET (26) ON VEHICLE FRAME. NOTE Be sure that hoses (13,  14 and 15) and boom electrical cable (25) are properly routed around tensioner (20). 16.    INSTALL  MLRS  ATTACHMENT,    TM10-3930-660- 20. 17. INSTALL MLRS ATTACHMENT CYLINDER,  TM10- 3930-660-20. NOTE Before   performing   step   18,   check   all   hydraulic   boom functions for proper operation. NOTE Apply Loctite 242 to threads of bolts (27) as installed. 18.        IF    REMOVAL    WAS    NECESSARY,        INSTALL RETAINER  (66).    PLACE  COVER  (29)  ON  REAR OF OUTER BOOM (2) AND SECURE WITH FOUR BOLTS   (27)   AND   FOUR   NEW   LOCKWASHERS (28). 19.    INSTALL  TRANSMISSION  COVER,    TM10-  3930- 660-20. 16-72