| |
TM10-3930-660-34
12-3 STEERING KNUCKLE - REPLACE/ADJUST (Cont’d)
7. REMOVE STEERING KNUCKLE (12) FROM
END OF AXLE .
8. REPEAT STEPS 1-5 FOR OTHER SIDE.
CLEANING
See Cleaning Instructions, para 2-10.
INSPECTION
See Inspection Instructions, para 2-11.
INSTALLATION
1. IF REMOVAL WAS NECESSARY, INSTALLGREASE
FITTING (6) IN CAPS (2 AND7)
2. APPLY GREASE IN BORES OF STEERING KNUCKLE FOR
CAPS
3. INSTALL STEERING KNUCKLE (12) END OF AXLE
4. INSTALL STEERING KNUCKLE CAP (7)
a. Apply grease to groove face of
thrust washer (8).
b. Install shims (9, 10 and 11)
and thrust washer (8) on lower
steering knuckle cap (7) Tabs
(B) on thrust washer must be up.
c. Install lower cap assembly
Ensure that thrust washer (8)
tabs engage slots in end of axle
housing before final tightening
of capscrews (1).
d. Apply Loctite 271 to threads of
capscrews (1) Tighten capscrews
(1) to 85-115 lb ft.
5. INSTALL UPPER STEERING KNUCKLE CAP
(2)
a. Install shims (3, 4 and 5) on
upper steering knuckle cap (2).
12-5
|
