TM10-3930-660-34 10-4 BRARK CONTROL VALVE - REPAIR (Cont’d e.  Install new filter (44), washer (43), new O-ring (42), seat (41), new poppet (40) and spring (39). f.  Install new O-ring (38) on adjusting screw (37) Install adjusting screws (37) and torque between 15-20 in lbs . g. Install nut (36) and torque between 15 and 20 lb ft. h. Install new O-rings (34 and 35) on insert (33) Use a wooden dowel to push insert (33) into valve. i. Install spool (32) into insert (33) Insert the short end of spool (32) first. j.Install ball (31) Ensure that ball (31) rests on insert (33). k.  Apply grease on end of spring (29) to hold stop (30) in place Install stop (30) with spring 29). l.  Install new O-ring (28) on plug (27) Install and torque plug (27) between 40 and 50 lb ft CAUTION Ensure that ball (26) is on seat (25) before proceeding Failure to do so could cause part damage m.  Apply grease to hold ball (26) and seat (25) to spring (24).   Install ball (26), seat (25) and spring (24). 10-14