TM 10-3930-660-34 9-5 . REAR DIFFERENTIAL CARRIER ASSEMBLY - REPLACE/REPAIR/ADJUST (Cont’d) CAUTION First four installed capscrews (4) must be evenly spaced to prevent uneven pressure on differential carrier (2) when torquing .  Failure to do so could cause component damage. c. Install four capscrews (4) and flatwashers (5) into corner locations around differential carrier (2) and axle housing (3) .  Hand tighten. d. Carefully push differential carrier (2) into position. Tighten four capscrews (4) two or three turns each in a pattern opposite each other. NOTE Torque capscrews (4) in pairs on opposing sides of differential carrier (2). e. Torque capscrews (4) to 50-75 lb. ft .  Torque in pairs across from each other. f. Install remaining eight capscrews (4) ,  two capscrews (6) ,  two capscrews (7) ,  four flatwashers (8) and eight flatwashers (5). Be sure fasteners are in correct location as noted during disassembly. g. Carefully install axle shafts (1) into axle housing (3) so not to damage bushings or seals in axle housing. h. Carefully move axle housing (3) to upright position. 2. INSTALL REAR PLANETARY WHEEL ENDS , PARA .  9-6. 3. FILL AXLE HOUSING WITH LUBRICANT , TM-10-3930-660-20. 4. INSTALL REAR AXLE ASSEMBLY ON VEHICLE ,  PARA .  9-3. 9-31