TM10-3930-660-34 8-5. FRONT DIFFERENTIAL CARRIER ASSEMBLY - REPLACE/REPAIR/ADJUST (Cont’d) g.   Use a 0.003 inch feeler gauge to check for gaps between back surface of ring gear (22) and flange case half (26).  If gauge fits more than half way to rivets,  remove ring gear (22); see DISASSEMBLY STEP 3,  a through d and repeat STEPS a through f. If gap persists,  inspect flange case half (26) and ring gear (22) for problem,  replace defective parts. h.   Use a press and suitable sleeve to install bearing cone (19) on flange case half (26). i. Use a press and suitable sleeve to install bearing cone (20) on plain case half (25). j. Apply gear lubricant to inside surfaces of both case halves (25 and 26) and no-spin differential (21). k.   Place flange case half (26) on bench,  ring gear (22) teeth up. l. Install no-spin differential (21) into flange case half (26). m. Place plain case half (25) over flange case half (26) and no-spin differential (21).  Rotate plain case half (25) as needed to align match marks. n.   Apply Loctite #277 to eight capscrews (23).  Install four of the eight capscrews (23) and four flatwashers (24) as opposing pairs (X and Y) into case halves (25 and 26). 8-24