TM10-3930-660-34 8-5. FRONT DIFFERENTIAL CARRIER ASSEMBLY - REPLACE/REPAIR/ADJUST (Cont’d) 5. INSTALL BEVEL PINION (12) AND BEARING CAGE (28) AS AN ASSEMBLY,  AND SHIM PACK (34) INTO THE CARRIER. 6. INSTALL BEARING CAGE COVER (30). a.   Install pinion bearing cage t thrust washer (32) on bevel pinion (12). b.   Place bearing cage cover (30) onto bearing cage (28) and secure with eight capscrews (29). c.   Torque capscrews (29) to between 50 and 75 lb.  ft. NOTE When installing capscrews (23) apply Loctite #277 to threads. 7. IF REMOVAL WAS NECESSARY,  INSTALL RING GEAR (22). CAUTION Ring gear (22) must be heated before installation.  Failure to heat ring gear (22) before installation could cause damage to differential case half (26) because of tight fit. a.   Expand ring gear (22) by heating in a tank of water to a temperature of 1600F to 180°F for 10 to 15 minutes. 8-22