TM10-3930-660-34 8-5. FRONT DIFFERENTIAL CARRIER ASSEMBLY - REPLACE/REPAIR/ADJUST (Cont’d) h.   Use a press or suitable sleeve and driver to install outer bearing cone (35) on bevel pinion against bearing spacer (37). 2. INSTALL BEVEL PINION BEARING OIL SEAL (31). a.   Apply a thin film of gear lubricant to inner surface of bevel pinion bearing oil seal (31). b.   Apply a thin film of gear lubricant to seal bore in pinion bearing cage cover (30). c.   Use a press or suitable sleeve and mallet to install bevel pinion bearing oil seal (31) into pinion bearing cage cover (30). d.   Use a feeler gauge to check gap between pinion bearing oil seal (31) flange and pinion bearing cage cover (30) at several points around the seal (31).  Gap must be within 0.015 to 0.030 inch. The difference between the largest and smallest gap measurements must not exceed 0.010 inch. 3. ADJUST PRELOAD OF BEARINGS (35,  36, 38 AND 39) ON BEVEL PINION (12). a.   Temporarily install bevel pinion (12) and bearing cage (28) assembly in differential carrier (2).Do not install shims (34) under bearing cage (28). b.   Install new gasket (33) on bearing cage (28). 8-17