TM10-3930-660-34 8-3. FRONT AXLE ASSEMLY - REPLACE/REPAIR (Cont’d) 5. INSTALL PARKING BRAKE ASSEMBLY, TM10-3930-660-20. 6. INSTALL TIE RODS, TM10-3930-660-20. 7. INSTALL STEERING CYLINDERS, TM10-3930-660-20. INSTALLATION 1. PLACE A STEEL BAR (1 INCH MINIMUM DIAMETER AND 6 FEET LONG) IN THE TILT CYLINDER ROD PIVOT PIN MOUNTING HOLE (A).   THE BAR WILL PREVENT THE AXLE ASSEMBLY FROM ROTATING WHEN INSTALLED. 2. USE A FLOOR JACK TO RAISE AXLE ASSEMBLY. 3. REMOVE STANDS. 4. LOWER AXLE ASSEMBLY UNTIL IT IS SUPPORTED BY TIRES. 5. ROLL AXLE ASSEMBLY UNDER VEHICLE, USING 6 FOOT BAR AND FLOOR JACK TO PREVENT THE AXLE ASSEMBLY FROM ROTATING. 6. ALIGN AXLE PIVOT PIN HOLE (B) WITH FRAME PIVOT PIN HOLES. 7. ENSURE WASHER SPACERS (10) ARE IN PLACE ON FRAME PIVOT PIN HOLE; USE FLOOR JACK TO CAREFULLY RAISE AXLE ASSEMBLY WHILE ASSISTANT HOLDS ASSEMBLY STEADY USING 6 FOOT BAR IN AXLE TILT CYLINDER MOUNTING HOLE ( A). 8. RAISE FLOOR JACK UNTIL AXLE PIVOT PIN HOLE (B) IS ALIGNED WITH FRAME PIVOT PIN HOLES. 9. SECURE FRONT AXLE TO FRAME WITH AXLE PIVOT PIN (11) AND WASHER SPACERS (10). AT LEAST ONE WASHER SPACER ON EACH SIDE OF AXLE PIVOT PIN HOLE IS REQUIRED. 8-7