TM10-3930-660-34 7-6.  TRANSMISSION OUTPUT SHAFT - REPLACE/REPAIR/ADJUST (Cont’d) CAUTION Use care when removing baffle pan (14).  Failure to follow this precaution will damage machine parts. d. Remove the output cap (10). The baffle pan (14),        gear (15) and bearing cone (16) will come off with output cap (10). e.   Remove two cap screws (17) and oil baffle pan     (14). f. Remove shims (18), O-ring (19), oil seal (20) and bearing cup (21) from output cap (10). Discard O- ring (19). g.   Remove plug (22) if necessary. h.   Remove plug (23) if necessary. i. Remove bearing cup (24) and oil seal (25) from   main case. CLEANING See Cleaning Instructions, para. 2-10. INSPECTION See Inspection Instructions, para. 2-11. INSTALLATION NOTE Bearing cones must not be heated above 300° F.  Freezing bearing cups is acceptable to aid for installation. 1. INSTALL PARTS (1-24). a.  Install oil seal (25) and bearing cup (24) in main case. b.  If removal was necessary, install plug (23). c.   If removal was necessary, install plug (22). 7-45