TMl0-3930-660-34 7-5. TRANSMISSION FRONT COVER ASSEMBLY - REPLACE/RPAIR (Cont’d) CLEANING See Cleaning Instructions,  para.  2-10. INSPECTION See Inspection Instructions,  para.  2-11. ASSEMBLY 1. IF REMOVAL WAS NECESSARY,  INSTALL PARTS (40- 46). a. If removal was necessary,  apply Loctite #59241 and install breather (46). b. If removal was necessary,  install identification plate (43) and four capscrews (44). c. If removal was necessary,  install oil passage cover (43) and three capscrews (42). d. If removal was necessary,  install sleeve (41).  Align index mark on sleeve (41) to center of locating hole. e. If removal was necessary,  apply Loctite #59241 and install two pipe plugs (40). NOTE When installing cover (35),  apply Loctite #242. 2. INSTALL  AUXILIARY  PUMP  DRIVE  PARTS  (32- 39). a. Install  snap  ring  (39)  and  bearing  (37)  in  front  cover (13). b. Install snap ring (36) inside front cover (13). c. Install bearing (37) on shaft (34). 7-40