| |
TM10-3930-660-34
7-4. TRANSMISSION ASSEMBLY - REPLACE/REPAIR (Cont’d)
f.
Press down on spring compressor tool and
retainer (80) to allow installation of retainer
ring
(81).
Slowly
remove
spring
compressor tool.
CAUTION
Carefully handle clutch plates (74) so graphite coating
doesn’t flake off. Failure to follow this precaution
could cause equipment damage.
g.
Install six clutch plates (74) and six
separator plates (75) into shaft assembly
(67). Begin with a separator plate (75) and
then a clutch plate (74). Continue by
alternating plates. The last plate must be a
clutch plate (74).
NOTE
The separator plates (75) have external teeth and
clutch plates (74) have internal teeth. The
plates do not have a right or wrong side for
installation.
h. Install retainer (73) on shaft assembly (67).
i.
Install snap ring (120).
j.
Install appropriate pair of alignment bars
between weld gear (70) and piston (84) as
required to hold weld gear (70) off piston
(84). Use either narrow or wide side of bars
to ensure that weld gear (70) is held off
piston (84) 1/8" and at the same time
engages all clutch plates (74).
k.
If removed, install snap ring (72) in weld
gear (70).
l.
Install weld gear (70) on shaft assembly (67).
7-26
|
