TM10-3930-660-34 7-4. TRANSMISSION ASSEMBLY - REPLACE/REPAIR (Cont’d) c. Remove two snap rings (90). d. Use a gear puller to remove weld gear (91) and bearing    (92)    as    an    assembly    from    shaft assembly (88). e. Using  an  assistant  to  spread  snap  ring  (121), use a driver to remove bearing (92) from weld gear (91). f. Remove snap ring (93) and clutch plate retainer (94) from shaft assembly (88). g. Remove    four    clutch    plates    (95)    and    four separator plates (96). NOTE The third stage clutch pack contains four clutch plates (95) and four separator plates (96). WARNING Springs (99) are under tension.  Always wear safety glasses when   working   on   compressed   springs.      Carefully   handle spring in compressed form.  Failure to follow this precaution could cause personal injury. h. Place shaft assembly (88) in a press.  Install a clutch spring compressor tool. i. Press   down   on   spring   compressor   tool   and retainer (97) just enough to relieve pressure on retainer  ring  (98).    Remove  retainer  ring  (98). Slowly remove clutch spring compressor tool. j. Remove  retainer  (97),    four  springs  (99)  and thrust washer (100). 7-19