TM10-3930-660-34 7-4. TRANSMISSION ASSEMBLY - REPLACE/REPAIR (Cont’d) b. Remove four capscrews (4), four lockwashers (5) and disconnect rear propeller shaft (6). Discard lockwashers (5). 3. TAG AND DISCONNECT LEAD (7) FROM TRANSMISSION TEMPERATURE SWITCH. 4. REMOVE FOUR CAPSCREWS (8), FOUR LOCKWASHERS (9) AND DISCONNECT TRANSMISSION PROPELLER SHAFT (10). DISCARD   LOCKWASHERS   (9).      SLIDE   YOKE   OF SHAFT (10) TOWARD ENGINE TO PROVIDE CLEARANCE. 5. DISCONNECT   TRANSMISSION   CABLES   (13   AND 14) FROM TRANSMISSION CONTROL VALVE. a. Remove  cotter  pin  (11)  and  washer  (12)  from each transmission cable (13 and 14) at transmission control valve.  Discard cotter pins (11). b. Remove four nuts (15) securing clamps for transmission cables (13 and 14). c. Disconnect   transmission   cables   (13    and    14)    from transmission    control    valve.        Tag    the    cables    for installation. CAUTION Wipe area clean around all hydraulic connections to be opened during  removal.  Cap  oil  lines  and  plug  holes  after  removing lines.    Contamination  of  the  hydraulic  system  could  result  in  - premature failure. NOTE If more than one hydraulic line is to be removed,  identify lines to  assure  proper  installation.    Use  suitable  container  to  catch any hydraulic oil that may drain from the system. 7-9