TM10-3930-660-34 7-4. TRANSMISSION ASSEMBLY - REPLACE/REPAIR This task covers: a. Removal b. Disassembly c. Inspection d. Reassembly f. Installation e. Pre-Load Check of Bearing INITIAL SETUP: Tools Materials/Parts Tool Kit,  Automotive Mechanics Cotter Pin (11) Gasket (115) Shop Equipment,  Automotive Grease (App.  B,  Item 11) Maintenance and Repair,  Common Lockwashers (2,  5,  9,  23,  27,  37) #1 Less Power Loctite #242 (App.  B,  Item 41) Oil Pan Tool Kit,  Transmission consisting of O-ring (25,  29,  64,  85,  102) the following: Seal (65,  86,  103) Lift,  Clutch Pack Tags (App.  B,  Item 52) Two Bearing Drivers Tie Wrap (19) Spring Compressor Tool Transmission Oil (App.  B,  Item 35) Wood Blocks Lifting Device,  Capacity 5 ton Personnel Required Fabricated Tools - Transmission Two Personnel Alignment Bars (App.  C,  Fig.  C-6) Cap and Plug Set Equipment Condition Transmission oil drained, LO10-3930-660-12. Transmission cover removed, TM10-3930-660-20. REMOVAL 1. RAISE   BOOM   TO   MAXIMUM   HEIGHT.      USE   A   HOIST   WITH SLING OR OTHER SUITABLE    DEVICE TO SUPPORT BOOM. 2. DISCONNECT SHAFTS (3 AND 6) FROM TRANSMISSION. a. Remove    four    capscrews    (1),        four    lockwashers    (2)    and disconnect  front  propeller  shaft  (3).  Discard  lockwashers  (2). Carefully lower front propeller shaft (3) to ground. 7-8