TM10-3930-660-34 7-3. TORQE CONVERTER - REPLACE/REPAIR (Cont’d) 2. REMOVE PARTS (13-15),  FRONT COVER (16),  PARTS (17-26) AND TURBINE (27). a. Remove twelve capscrews (13), twelve lockwashers (14) andconverter input shaft (15).Discard lockwashers (14). b. Mark front cover (16) and impeller (17) for assembly. Remove twenty hex nuts (18), twenty flatwashers (19), twenty capscrews (20) and front cover (16). c. Remove outer thrust race (21), needle thrust bearing (22) and inner thrust race (23). d. Use a suitable puller tool and remove bearing (24). e. Remove and discard O-ring (25) from front cover (16). f. Remove turbine hub (26) and turbine (27). 3. REMOVE PARTS (28-30),  STATOR (31) AND DISASSEMBLE PARTS (32-36). a. Remove outer thrust washer (28), needle thrust bearing (29),  inner thrust washer (30) and stator (31) from impeller (17). b. Remove two retaining rings (32), two clutch retainers (33),  inner race (34), sprag clutch assembly (35) and outer race (36). 7-4