| |
TM10-3930-660-34
6-9. ELECTRIC JOYSTICK ASSEMBLY - REPAIR/TEST/ADTUST (Cont’d)
d. Solder yellow electrical lead of joystick to pin 2
of pushbutton switch (16)
e. Solder green jumper lead to pin 1 and pin 3 of
pushbutton switch (16).
f.
Solder red electrical lead of joystick to pin 4 of
pushbutton switch (16)
2.
INSTALL PARTS (8) THROUGH (13) AND
PARTS (15) THROUGH (18) TO HANDLE
SECTIONS (7).
NOTE
Align handle section (7) on shaft coupling (14) so that
coupling set screw (20) is facing center of handle section
(7).
a. Place one handle section (7) on shaft coupling
(14).
Place switch flange (18) in lowest slot with flat surface of
flange facing center of handle section (7).
b. Install pushbutton switch (16), flange (18), and
nut (17) as a unit to handle section (7).
c. Install actuating button (15) with smaller
diameter of button extending through top of
handle section (7).
d. Place other handle section (7) on shaft
coupling (14).
e. Install two screws (11), two new bowed
washers (12) and two nuts (13) at bottom of
handle sections (7).
6-35
|