TM10-3930-660-34 6-4.  STARTER - REPAIR (Cont’d) c.  Remove four screws (17 and 18) and four brushes (19).  Two brush ground leads (20) are also attached with screws (17). d.  Remove brushes (19) from holders (13 and 14). e.  If necessary, remove four rivets (21) and two supports (16).  Discard rivets (21). NOTE Remove field winding coil (22) only if known to be grounded or open.  If it is being removed, use a pole spreader and a pole shoe screwdriver. f.  Match mark all four shoes (23) and adjacent area of field frame (8), to ensure proper installation. g.  Remove eight screws (24), four shoes (23) and field winding coil (22). 7.   REMOVE SOLENOID SWITCH AND RELATED PARTS. a.  Remove two capscrews (25) and separate cover (26) and gasket (27) from solenoid switch housing (28).  Remove contact (29).  Discard gasket (27). b.  Remove two screws (30) and lockwashers (31).  Discard lockwashers (31). c.  Remove solenoid switch (28), gasket (32) and plunger return spring (33).  Discard gasket (32). d.  Remove pin (34) and plunger (35). e.  Remove screw (36), nut (37), lockwasher (38) and shift lever (39).  Discard lockwasher (38). 6-12