TM10-3930-660-34 6-3.  ALTERNATOR - REPAIR/TEST (Cont’d) d.  Remove ball bearing (14) by pressing towards inside of drive end frame (4).  Apply pressure against I.D.  of bearing (14). e.  Remove dust shield (15). 5.   REMOVE THREE NUTS (16) THAT CONNECT STATOR LEAD TERMINAL CLIPS (17) TO DIODE TRIO (18). 6.   REMOVE STATOR (8) FROM SLIP RING END FRAME (5). 7.   DISASSEMBLE SLIP RING END FRAME (5) COMPONENTS. a.  Remove insulated screw (19) securing diode trio (18) to brush and holder assembly (20). Remove diode trio (18). NOTE Screws (21) and springwashers (22) are located on the rectifier bridge (23), closest to outside of frame (5).  One of the screws (21) secures the lower contact of capacitor (24). b.  Remove two screws (21) and two springwashers (22) from rectifier bridge (23).  Discard springwashers (22). NOTE Screw and lockwasher assemblies (25) are located on the rectifier bridge (25), closest to center of frame (5).  One assembly (25) secures the upper contact d.  Remove rubber cover (27) from of capacitor (24).  The other assembly terminals of regulator (28. (25) secures wire lead (26). e.  Remove insulated screw (19), screw c.  Remove two screw and lockwasher (29), and lockwasher (30), securing assemblies (25) from rectifier brush and holder assembly bridge (23).  Remove capacitor (24) (20), brush springs (31), and and rectifier bridge (23) from regulator (28).  Discard lockwasher frame (5).  Discard screw and (30).  Remove parts (20), (28), and lockwasher assemblies (25). (31) from frame (5). 6-4