TM10-3930-660-34 4-6. TURBOCHARGER ASSEMBLY - REPAIR (Cont’d) c.  Move end of impeller (13) left and right and read radial clearance on dial indicator.  If radial clearance is less than 0.012 inch or greater than 0.018 inch,  disassemble turbocharger,  STEPS 1-19,  and check for problem.  Replace defective parts and assemble, STEPS 1-33. 34.  IF REMOVAL WAS NECESSARY,  INSTALL DATAPLATE (8) AND SECURE WITH FOUR DRIVESCREWS (7). 35.  INSTALL RING SEAL (6) ONTO TURBOCHARGER DIFFUSER (13). 36.  APPLY LOCTITE #767-64 TO V-BAND CLAMP (5) BOLT THREADS. 37.  INSTALL COMPRESSOR HOUSING (1) AND V-BAND CLAMP ONTO DIFFUSER (13). TIGHTEN NUT (4) TO 120 LB.  IN. 38.  TAP CLAMP (5) IN FOUR PLACES,  900 APART TO SEAT CLAMP. 39.  TIGHTEN NUT (4) TO 120 LB.  IN.  AGAIN. 4-23