| |
TM10-3930-660-34
4-6.
TURBOCHARGER ASSEMBLY - REPAIR (Cont’d)
11. APPLY ENGINE OIL TO NEW THRUST
BEARING (19).
12. INSTALL NEW THRUST BEARING (19) AND
SECURE WITH THREE NEW CAPSCREWS
(18).TORQUE CAPSCREWS TO 40 LB.
IN.
13. INSTALL OIL BAFFLE (17) ONTO SHAFT
(24).
14. INSTALL NEW SPLIT RING OIL SEAL (16)
ONTO OIL SLINGER (15).
15. MARK TOP SURFACE OF OIL SLINGER (15)
IN LINE WITH BALANCE MARK.
16. APPLY ENGINE OIL TO OUTSIDE OF OIL
SLINGER (15).
17. INSTALL OIL SLINGER (15) AND NEW
SPLIT RING OIL SEAL (16) INTO
DIFFUSER (13). INSTALL NEW RING
SEAL (14) INTO DIFFUSER (13).
19. ALIGN BALANCE MARKS ON SHAFT (24)
AND OIL SLINGER (15).
20. INSTALL OIL SLINGER (15) AND
DIFFUSER (13), AS AN ASSEMBLY, ONTO
SHAFT (24).
CAUTION
When installing impeller (10), be sure
to align balance marks on shaft (24) and
impeller (10). Failure to do so could
cause premature component failure.
CAUTION
Do not move bearing housing (2) when
installing impeller (10). Moving
bearing housing (2) during impeller (10)
installation will cause improper balance
and premature component failure.
21. INSTALL IMPELLER (10) ONTO SHAFT
(24).
4-20
|