TM10-3930-660-34 4-4.  FUEL INJECTION PUMP - REPLACE (Cont’d) k.  Install brace (21) and three capscrews (20).  Leave capscrews (20) finger tight until certain that brace (21) is properly positioned. l.  In order,  tighten two brace-to- block capscrews (20) and then one brace-to-pump flange capscrew to a torque of 216 in.  lb. m.  Tighten nuts (13). 3.  CONNECT ELECTRICAL LEAD (18) TO FUEL SHUTOFF VALVE,  CONNECT FUEL DRAIN LINE (17),  CONNECT FUEL SUPPLY LINE (16) AND CONNECT SIX HIGH FUEL PRESSURE LINES (15) TO FUEL INJECTION PUMP (19). 4.  INSTALL STE/ICE PULSE TACHOMETER AND DRIVE. a.  Install hub (11) on shaft (12). b.  Install new seal (10) and cover (6). c.  Install new gasket (7),  drive (2), two screws (8),  and two flatwashers (9). d.  Install tachometer (1) on drive (2) and tighten nut. e.  Connect male connector (3) to female connector (4) on wiring harness (5). 5.  CONNECT BATTERIES,  TM10-3930-660-20. 6.  BLEED FUEL LINES,  PARA.  4-3. 4-13