TM 10-3930-660-34 3-19.  FRONT HOUSING AND COVER - REPIACE/REPAIR (Cont’d) d.   Apply a bead of Loctite #277 to outside of new seal (12). e.   Press seal (12) and seal pilot onto crankshaft end. f. Remove seal pilot from seal (12). g.   Use alignment/installation tool included in seal kit to drive seal to correct depth in cover (7) bore. 7. IF OLD SEAL (12) IS TO BE RE-USED: a.   Install seal pilot from seal kit into inside diameter of seal (12) tc protect lips of seal (12) during installation. b.   Install new gasket (8) onto housing (9). c.   Install seal (12) and cover (7) onto housing (9) as an assembly. d.   Install eight capscrews (5) and eleven capscrews (6) through gear cover (7) and into gear housing (9). Torque capscrews to 216 in. lb. 8. INSTALL CAPSCREW (3) AND BELT GUIDE (4). TORQUE CAPSCREW (4) TO 216 IN. LB. 9. INSTALL VIBRATION DAMPER (2) AND RETAIN WITH FOUR CAPSCREWS (1).  TIGHTEN CAPSCREWS (1) EVENLY TO 101 LB. FT. 10. INSTALL FAN AND DRIVE BELT, TM 10-3930- 660-20. 11. INSTALL TACHOMETER DRIVE, TM 10-3930-660- 20. 12. INSTALL ENGINE, PARA. 3-3. 3-121