TM 10-3930-660-34 3-18. CAMSHAFT, GEAR, AND CAMSHAFT BUSHING - REPLACE (Cont’d) d.   Check oil hole alignments by inserting a 0.128 inch diameter rod into bushing oil hole (8) and insuring that rod can also enter oil hole (7) in camshaft bore.  Remove and reinstall camshaft bushing (5) if oil hole alignment is unsatisfactory. NOTE The specified rod diameter represents the minimum sized oil passage required for adequate camshaft bushing lubrication. 2. APPLY LUBRIPLATE 105 TO CAMSHAFT BORES IN CYLINDER BLOCK AND TO LOBES OF CAMSHAFT. 3. INSTALL CAMSHAFT/GEAR/THRUST PLATE. a.   Position camshaft/gear/thrust plate in cylinder block. b.   Align timing marks on camshaft gear with timing mark on crankshaft gear. c.   Install capscrews (1) in thrust plate (2) and tighten to 216 in. lb. (24 N.m). 4. INSTALL ROCKER ARM LEVERS, PARA. 3-16. 5. INSTALL FUEL TRANSFER PUMP, TM 10-3930- 660-20. 6. INSTALL FRONT HOUSING COVER, PARA. 3-19. 7. INSTALL OIL PAN, PARA. 3-20. 3-116