TM 10-3930-660-34 3-9.  CRANKSHAFT MAIN BEARINGS - REPLACE (Cont’d) g. Apply    a    light    coat    of    lubricating    oil    on threads of capscrews (1). h. Install bearing (4), bearing cap (2)  and  two capscrews  (1)  on  the  number  one  bearing bore in the cylinder block. i. Alternately   tighten   two   capscrews   (1)   to final torque value in these three steps: Step Torque Value 1 .....................................................................44 lb. ft. 2 .....................................................................88 lb. ft. 3 ...................................................................129 lb. ft. j. Check number 1 main bearing clearance, STEPS 2a and 2b. k. Remove number 1 main bearing, STEPS 4b, 4c, and 4d. 6. CHECK NUMBER 7 MAIN BEARING (3 AND 4) CLEARANCE. a. Install number 7 main bearing, STEPS la through lj. b. Alternately tighten capscrews (1) to final torque value in these three steps: Step Torque Value 1 .....................................................................44 lb. ft. 2 .....................................................................88 lb. ft. 3 ...................................................................129 lb. ft. c. Check bearing clearance, STEPS 2a through 2f. 3-78