TM 10-3930-660-34 3-8. CRANKSHAFT - REPLACE/REPAIR (Cont’d) c. Remove two capscrews (8) and connecting rod caps (7) from connecting rods (9). d. Push pistons and connecting rods away from crankshaft.  Discard capscrews (8). NOTE Do not reuse connecting rod capscrews (8). e. Remove upper bearing half (10) from connecting rods (9) and lower bearing half (11) from connecting rod caps (7).  Keep connecting rod caps and bearing halves together as a set. NOTE The four digit number stamped on the connecting rod and connecting rod cap are the same.  Connecting rod and cap are machined as a set and must be kept that way. 5.   REPEAT STEPS 4A THROUGH 4E FOR REMAINING CONNECTING ROD CAPS AND BEARINGS. 3-53