 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
TANDEM GEAR PUMP MAINTENANCE - CONTINUED
0302 00
ASSEMBLY - CONTINUED
10.
Install new seals (24 thru 26) in thrust plate (23) with flat side of new seal (24) facing away from thrust plate.
11.
Slip thrust plate (23) over gears (27 and 28) and into
18
gear housing bore (21). The flat side of seal should be
26
facing outlet side.
25
CAUTION
24
25
26
If parts are difficult to fit during assembly,
23
20
tap with a soft hammer. Use care to pre-
vent part damage.
17
21
12.
Ensure that dowel pins (20) are in place. Install bear-
22
ing carrier (18) onto gear housing (21). Align dowel
19
holes over dowel pins. Use a soft hammer to tap parts
together.
6
19
13.
Install connecting shaft (22) in spline of drive gear
409-1373
(27).
14.
Apply grease on two new seals (19). Install seals into grooves on gear housing (6).
CAUTION
If parts are difficult to fit during assembly, tap with a soft hammer. Use care to prevent part damage.
15.
Ensure that dowel pins (17) are in place. Install gear
housing (6) onto bearing carrier (18). Align dowel
holes over dowel pins. Use a soft hammer to tap parts
together. Use care to prevent damage to new seals
(31).
16.
Install new seals (14 thru 16) into grooves in thrust
plate (13) with flat side of new seal (14) facing away
8
from thrust plate.
10
9
17.
Install drive gear (11) and driven gear (12) into bear-
7
11
ing carrier (15). Ensure that gears are in contact with
thrust plate (13) face.
13
9
16
10
18.
Install new seals (8 thru 10) into grooves in thrust
14
plate (7) with flat side of new seal facing away from
thrust plate.
12
19.
Install thrust plate (7) with new seals over gears (11
15
15 16
409-1372
and 12). The flat side of new seal (8) should be facing
up with relief groove facing outlet side.
0302 00-5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals