 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
TRANSMISSION ASSEMBLY REPAIR - CONTINUED
0289 00
ASSEMBLY - CONTINUED
WARNING
Springs are under tension. Always wear face shield when working on compressed springs. Carefully handle
spring in compressed form. Failure to follow this precaution could cause personal injury.
9.
Place shaft assembly (7) in a press. Install a spring
compressor tool.
7
6
8
409-1155
WARNING
Ensure that retainer ring is secure in groove before spring compressor tool is removed from retainer to pre-
vent springs from flying out. Failure to follow this precaution could cause personal injury.
10.
Press down on spring compressor tool and retainer
21
(17) to allow installation of retainer ring (18). Slowly
7
remove spring compressor tool.
15,16
CAUTION
17,18
Carefully handle clutch plates so graphite
coating does not flake off. Failure to fol-
14
low this precaution could cause equipment
19
13
damage.
20
11.
Install six separator plates (16) and six clutch plates
22
(15) into shaft assembly (7). Begin with separator
plate (16) and then a clutch plate (15). Continue by
alternating plates. The last plate must be a clutch plate
(15).
NOTE
The separator plates have external teeth
and clutch plates have internal teeth. The
plates do not have a right or wrong side for
409-1157
installation.
12.
Install retainer (14) and snap ring (13) on shaft assem-
bly (7).
0289 00-13
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals