 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
TRANSMISSION ASSEMBLY REPAIR - CONTINUED
0289 00
DISASSEMBLY - CONTINUED
31.
Remove snap ring (37).
32.
Use a gear puller to remove weld gear (38) and two
26
bearings (39) as an assembly from shaft assembly
37
(26).
39
38
409-1164
WARNING
Springs are under tension. Always wear face shield when working on compressed springs. Carefully handle
spring in compressed form. Failure to follow this precaution could cause personal injury.
33.
Place shaft assembly (26) in a press. Install a clutch spring compressor tool.
34.
Press down on spring compressor tool and retainer (40) just enough to relieve pressure on retainer ring (41). Remove
retainer ring (41). Slowly remove clutch spring compressor tool.
35.
Remove retainer (40), four springs (42) and thrust washer (43).
26
44
40
WARNING
Do not exceed 15 psi (103 kPa) nozzle
45
pressure when using compressed air. Do
not direct compressed air against skin.
Failure to follow this precaution could
43
cause personal injury.
41
36.
Insert air nozzle at pressure ports (44) located between
42
three seal ring grooves on shaft assembly (26). Use
compressed air to remove piston (45).
409-1165
0289 00-7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals