 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
TORQUE CONVERTER REPAIR - CONTINUED
0288 00
DISASSEMBLY - CONTINUED
6.
Remove outer thrust washer (13), needle thrust bear-
13
14
ing (14), inner thrust washer (15) and stator (16) from
15
21
impeller (2).
20
7.
Remove retaining ring (17), two clutch retainers (18),
19
inner race (19), sprag clutch assembly (20) and outer
race (21).
2
17
18
16
409-1140a
8.
Remove outer thrust washer (22), needle thrust bear-
22
23
24
ing (23) and inner thrust washer (24).
27
2
9.
Remove eight capscrews (25), eight flatwashers (26)
28
and impeller hub (27) from impeller (2).
10.
Remove and discard O-ring (28) and seal ring (29).
26
25
29
409-1141
CLEANING
See Cleaning instructions (WP 0316 00).
INSPECTION
See Inspection instructions (WP 0317 00).
ASSEMBLY
NOTE
Wipe all sealing surfaces clean and dry. Apply a thin film of clean lubricating oil to all seals and bearings as
they are installed.
1.
Install new O-ring (28) at base of impeller hub (27).
2.
Install new seal ring (29) on impeller hub (27).
3.
Install impeller hub (27), eight capscrews (25) and eight flatwashers (26). Torque capscrews (25) to 25 lb-ft (34 Nm).
4.
Install inner thrust washer (24), needle thrust bearing (23) and outer thrust washer (22).
0288 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals