 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
TURBOCHARGER ASSEMBLY REPAIR (165 HP) - CONTINUED
0282 00
ASSEMBLY - CONTINUED
6.
Position heat shield (21) on bearing housing (14).
7.
Install seal ring (22) on shaft and wheel (19).
CAUTION
Ensure that seal ring gap is positioned 180 degrees from bearing housing drain hole to prevent damage to
turbocharger assembly.
8.
Install turbocharger shaft and wheel (19) and seal ring (22) as an assembly in bearing housing (14).
9.
Apply engine oil on turbocharger shaft and wheel (19) shaft.
10.
Support turbocharger shaft and wheel (19) and bearing housing (14) in a suitable fixture.
CAUTION
When installing thrust collar ensure balance mark on collar is aligned with shaft and wheel shaft balance
mark. Mark top surface of thrust collar so alignment can be verified after installing thrust bearing. Failure to
align balance marks could cause premature component failure.
11.
Install thrust collar (30) on turbocharger shaft and
wheel (19).
30
14
21
19
22
409-1828
0282 00-7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals