 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
CONNECTING RODS AND BEARINGS MAINTENANCE - CONTINUED
0277 00
INSTALLATION
NOTE
If required, replace piston rings (WP 0276 00) before proceeding.
1.
Assemble connecting rod (6) to piston (3).
2.
Liberally apply clean lubricating oil to piston pin (8) and to piston pin bores in connecting rod (6) and in piston (3).
3.
Install retaining ring (11) on side of piston marked FRONT.
4.
Orient piston (3) and connecting rod (6) so word FRONT, on top of piston (3), and no. stamped on connecting rod, are
positioned as shown.
6
11
409-970
3
409-969
5.
Install piston pin (8) through bores in piston (3) and in connecting rod (6).
6.
Install retaining ring (7).
7.
Install piston (3) and connecting rod (6) assembly.
8.
Apply clean lubricating oil to cylinder bores, piston
6
rings and piston skirts.
3
7
8
409-980
CAUTION
If a strap-type ring compressor is used, do not hook strap on gap of ring. This could cause piston ring to
break.
9.
Compress piston rings using ring compressor (WP 0276 00).
0277 00-5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals