 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
CRANKSHAFT REAR SEAL REPLACEMENT - CONTINUED
0274 00
REMOVAL
1.
Drill two 1/8 in. (3.175 mm) holes 180 degrees apart in seal carrier.
2.
Remove rear crankshaft seal with slide hammer puller.
3.
Insert a no. 10 sheet metal screw into end of slide hammer puller.
4.
Alternately put slide hammer puller into the two 1/8 in. (3.175 mm) drilled holes and pull until oil seal (1) is removed.
Discard rear oil seal.
1
1
409-956
409-957
INSTALLATION
CAUTION
The seal lip and sealing surface on crankshaft must be clean to help prevent an oil leak around the seal.
Always use the seal pilot to install rear oil seal. Failure to do so could result in a damaged oil seal.
1.
Install seal pilot (2) supplied with seal kit into crankshaft.
2.
Install new oil seal (1) over seal pilot (2) and onto crankshaft.
3.
Remove seal pilot (2) from crankshaft.
2
1
409-959
409-958
0274 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals