 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
BOOM ASSEMBLY REPLACEMENT - CONTINUED
0261 00
REMOVAL - CONTINUED
NOTE
Center of gravity for boom assembly is approximately 9 ft (2.74 Nm) from rear end of boom assembly.
CAUTION
To prevent damage to lines and electrical cable during step 21, place wood boards between underside of
outer boom section and slings.
22.
Reposition hoist and slings to center of gravity for
boom assembly (8). Carefully raise boom assembly
(8) until weight of boom is removed from boom pivot
8
pins (16).
23.
Remove capscrew (17) and locknut (18) securing
boom pivot pin (16) to vehicle frame. Discard locknut.
17
NOTE
Shims may fallout as pivot pins are
removed.
24.
Remove boom pivot pin (16) from boom assembly (8)
16
from vehicle frame.
18
19
25.
Remove shims (19) from between boom assembly (8)
and vehicle frame. Note quantity and position of shims
(19) for use during Installation.
26.
Repeat steps 23 thru 25 for other boom pivot pin.
409-1398
0261 00-6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals