|
|
TM 10-3930-660-24-2
PISTON PUMP MAINTENANCE - CONTINUED
0256 00
DISASSEMBLY - CONTINUED
WARNING
Spring located in the cylinder block is under high tension and can cause severe personal injury if retaining
ring is not removed correctly.
12.
Place flatwashers (A), as required, under head of cap-
screw (B). Slide capscrew (B) through retaining ring
17
(21) and spring (20) until threaded end of capscrew is
A
visible through hole on other side of cylinder block
C
(17).
B
13.
Place additional flatwashers (A), as required, and nut
22
A
20
(C) on threaded end of capscrew (B).
23
14.
Carefully tighten nut (C) and capscrew (B) until
21
spring tension is removed from retaining ring (21).
409-1474
NOTE
Use care when handling close tolerance parts that are removed in steps 15 and 16, to prevent burrs from
forming.
15.
Remove retaining ring (21). Carefully loosen nut (C)
and capscrew (B) until spring (21) is fully extended.
6
Separate spring washer (22), spring (21) and spring
washer (23) from cylinder block (17).
16.
Remove yoke (26) and shaft (15).
26
15
409-1475
0256 00-3
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |