 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
REAR PLANETARY WHEEL ENDS REPLACEMENT - CONTINUED
0248 00
CLEANING
See Cleaning instructions (WP 0316 00).
INSPECTION
See Inspection instructions (WP 0317 00).
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death.
INSTALLATION
1.
Align the match marks on the spider flange and wheel
hub as previously marked during removal.
2.
Align holes on wheel hub (2) with holes on planetary
spider (1) flange and push spider assembly against hub
(2).
3.
Install sixteen capscrews (3) and flatwashers (4).
4.
Tighten capscrews (3) and torque to 60 to 75 lb-ft (81
2
to 102 Nm).
3,4
A
1
A
A
409-1312
5.
Fill rear planetary wheel ends (WP 0126 00).
6.
Install rear disc brake assembly (WP 0249 00).
7.
Install tire assembly (WP 0134 00).
8.
Operate vehicle and check for proper operation (TM 10-3930-660-10).
END OF WORK PACKAGE
0248 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals