INSTALLATION - CONTINUED -832450235

TM 10-3930-660-24-2

FRONT PLANETARY WHEEL ENDS REPLACEMENT - CONTINUED

0244 00

INSTALLATION - CONTINUED

WARNING

Minor concentrations of acetic acid may be produced during application of silicone TRTV-732 sealing com-

pound. Adequate ventilation must be provided when silicone RTV-732 clear sealing compound is applied in

confined areas. Failure to do so could cause respiratory irritation, headaches and nausea. Eye contact with

silicone RTV-732 sealing compound may cause irritation. If eye contact takes place, flush eyes with water

for 15 minutes and have eyes examined by a doctor.

28.

Apply a continuous bead of sealing compound approximately 1/8 in. in diameter completely around the hub mounting

face and around the inner edge of all fastener holes to ensure complete sealing and prevent leakage.

NOTE

Assemble components immediately to permit sealing compound to spread evenly. Failure to do so could

cause axle to leak.

29.

Start planetary spider (1) onto wheel hub (2), aligning teeth of planetary gears (8) with sun gear (11) and ring gear (13)

teeth.

30.

Align the match marks on the spider flange and wheel hub as previously marked during removal.

31.

Align holes on wheel hub (2) with holes on planetary

spider (1) flange and push spider assembly against hub

(2).

3,4

32.

Install sixteen capscrews (3) and flatwashers (4).

33.

Torque capscrews (3) and torque to 60 to 75 lb-ft (81

to 102 Nm).

34.

Fill planetary wheel ends (WP 0126 00).

35.

Install front disc brake assembly (WP 0249 00).

409-1270

36.

Install wheel assembly (WP 0134 00).

37.

Operate vehicle and check for proper operation (TM 10-3930-660-10).

END OF WORK PACKAGE

0244 00-7/(-8 Blank)