 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
FRONT AXLE ASSEMBLY REPLACEMENT - CONTINUED
0241 00
REMOVAL
1.
Place wood blocks between frame pads (1) on rear
axle and frame tilt stop pads (2). This will prevent
frame from tilting when removing front tilt cylinders.
2
1
409-1227
WARNING
Do not raise or extend boom until the frame is level. Failure to do so could cause the load to drop or machine
to tip.
Do not raise or extend boom unless the frame is level.
Extreme care must be taken to ensure that the boom does not come near overhead wires. Death or injury may
result from contacting power lines. Never operate this vehicle close to electric power or other lines. If lines
are near to your operating area, notify your supervisor of the lines prior to starting work.
2.
Start engine and raise boom for sufficient work clearance (TM 10-3930-660-10).
3.
Disconnect parking brake cable (WP 0127 00).
4.
Remove front propeller shaft (WP 0124 00).
0241 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals