|
|
TM 10-3930-660-24-2
BOOM ELECTRICAL BOX ASSEMBLY MAINTENANCE - CONTINUED
0229 00
DISASSEMBLY
1.
Remove four screws (not shown) and enclosure cover
(1).
2
1
2.
Tag and disconnect four wires connected circuit board
(2) and terminal strip (3).
3
7,8
409-1117
3.
Remove four screws (4) and four lockwashers (5)
from connector (6). Connector is part of circuit board
(2). Discard lockwashers.
11
4.
Remove four nuts (7) and four screws (8) to remove
circuit board (2).
5.
Cut cable ties (12) from cable to be removed.
15
10
15
10
6.
Remove cables (9 thru 11) as necessary for replace-
13
ment.
12
6
7.
Tag and disconnect cable wires from terminal strip
18
(13).
8.
Push grommets (14 and 15) to outside of enclosure,
using care not to damage grommet.
4,5
9.
Remove and discard grommets (14 and 15) from cable
(9 thru 11).
12
21
12
19,20,22
14
10.
Remove screw (16) and lockwasher (17) and discon-
16,17 15
9
nect wire assembly (18) from lower terminal strip (13)
and from terminal strip (3). Discard lockwasher.
11.
Remove eight screws (22), nuts (19) and lockwashers
(20) to remove terminal strips (13). Discard lockwash-
ers.
409-1118
12.
Remove two jumper terminals (21).
0229 00-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |