INSTALLATION - CONTINUED -832450064

TM 10-3930-660-24-2

ENGINE ASSEMBLY REPLACEMENT (165 HP) - CONTINUED

0210 00

INSTALLATION - CONTINUED

125

126

133

135

WARNING

124

Use caution when handling heavy parts. Provide

121

adequate support and use assistance during pro-

123

cedure. Ensure that any lifting device used is in

122

good condition and of suitable load capacity.

132

Keep clear of heavy parts supported only by lift-

ing device. Failure to follow this warning may

cause injury or death.

NOTE

135

Engine assembly weighs 1,075 lb (488 kg).

120

131

12.

Install two front rubber mounts (135) and rear rubber

119

mount (136) on right and left front engine mounts

129

(122 and 126) and rear engine mount (130).

13.

Attach lifting chains to front and rear engine lifting

brackets (132 and 133).

14.

Attach lifting chains to forklift truck forks or other

suitable lifting device. Slowly lift and install engine

130

through the back of the engine compartment. Lift

engine high enough to clear rear frame support bar

136

(134).

128

15.

Lower engine into position over rubber mounts and

127

409-1807

install screw (129), rebound washer (128) and new

locknut (127) on rear engine mount (130).

16.

Install screw (125), rebound washer (124) and new

locknut (123) on left front engine mount (126).

TR01345

17.

Install screw (121), rebound washer (120) and new

locknut (119) on right front engine mount (122).

18.

Remove lifting device and lifting chains from engine

lifting brackets (132 and 133).

19.

Torque locknuts (119, 123 and 127) to 307 lb-ft (416

Nm).

134

409-1808

0210 00-16