 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-2
ENGINE ASSEMBLY REPLACEMENT (152 HP) - CONTINUED
0209 00
REMOVAL - CONTINUED
43.
Attach lifting chains, with a lifting capacity of 2,000 lb (907 kg) to engine lifting brackets.
44.
With assistance, raise engine high enough to clear rear frame support bar.
45.
Slowly remove engine through the back of the engine
compartment.
46.
Place engine in a suitable engine stand.
NOTE
There are two front rubber mounts; one
under each of the two front engine mounts.
47.
Remove and discard two front rubber mounts (72) and
rear rubber mount (73).
REAR FRAME SUPPORT BAR
409-822
48.
Remove alternator (WP 0062 00).
49.
Remove STE/ICE-R fuel pressure sender (WP 0087 00) and STE/ICE-R fuel filter differential pressure switch (WP
0088 00).
50.
Remove starter relay (WP 0081 00).
51.
Remove transmission oil sampling valve and fittings (WP 0121 00).
52.
Remove engine oil pressure and water temperature switches (WP 0073 00 and WP 0075 00).
53.
Remove engine oil pressure and water temperature senders (WP 0099 00 and WP 0100 00).
54.
Remove engine mounts (WP 0211 00).
55.
Remove flywheel housing cover (WP 0215 00).
56.
Remove coupling from flywheel (WP 0214 00).
57.
Remove ether start thermostat (WP 0046 00).
INSTALLATION
1.
Install engine mounts (WP 0211 00).
2.
Install ether start thermostat (WP 0046 00).
3.
Install water temperature and oil pressure senders (WP 0099 00 and WP 0100 00).
4.
Install engine oil pressure and water temperature switches (WP 0073 00 and WP 0075 00).
5.
Install oil sampling valve and fittings (WP 0121 00).
6.
Install starter relay (WP 0081 00).
0209 00-13
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals