 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-1
HYDRAULIC OIL FILTER REPLACEMENT - CONTINUED
0199 00
REMOVAL
1.
Remove hydraulic filter element (1) from filter base
8,9,10
(2). Discard filter element.
2.
At hydraulic filter base (2), remove hose (3) and
6
4
elbow (4) from filter base. Plug hose.
5
2
3.
Remove sampling valve (5) from elbow (6).
A
4.
Remove elbow (6).
7
5.
Remove four screws (8), lockwashers (9) and flat-
washers (10). Discard lockwashers.
6.
Remove filter base (2) from the vehicle.
B
1
INSTALLATION
NOTE
3
Remove caps and plugs as hoses are
installed. Wipe all sealing surfaces on
valve and hoses clean and dry. Apply film
of clean hydraulic oil to all seals as they
409-781
are installed.
NOTE
Apply loctite 242 to threads of screws as installed.
1.
Support and position filter base (2) on vehicle. Install four flatwashers (10), four new lockwashers (9) and four screws
(8) to secure filter base to vehicle.
2.
Install elbow (6).
3.
Apply loctite 59241 to threads of sampling valve (5) and install sampling valve into elbow (6). Be sure drain end of
valve (A) is facing down.
4.
Install elbow (4) and hose (3) to filter base (2).
5.
Lubricate the seal (B) on filter element (1) with a thin coat of clean oil.
6.
Install new filter element (1) onto base (2).
7.
Start and run engine for one minute. Check for leaks at filter assembly and at hydraulic connections (TM 10-3930-660-
10).
8.
Refill hydraulic tank (WP 0032 00).
9.
Install transmission cover (WP 0150 00).
END OF WORK PACKAGE
0199 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals