 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-1
BOOM HOSE PULLEY REPLACEMENT - CONTINUED
0191 00
REMOVAL
1
1.
Fully retract, then extend boom several inches (TM
10-3930-660-10).
2
2.
Disconnect battery cables (WP 0107 00).
3.
Loosen jamnuts (1) at tensioner (2) to relieve tension
on three hydraulic hoses (3) and boom electrical cable
(4).
4.
Disconnect three hydraulic hoses (3) at fittings (5)
4
behind tensioner (2).
5
3
409-4002
NOTE
Rope is used to pull hoses out of boom during installation.
5.
Tie a rope around ends of disconnected hydraulic
hoses (3).
4
6.
Remove four clamp assemblies (6) securing boom
electrical cable (4) to underside of boom.
6
409-732
7.
Remove four capscrews (7), four lockwashers (8) and
access cover (9). Discard lockwashers.
89
8.
Disconnect boom electrical cable (4) at plug (10).
7
10
4
409-733
0191 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals