 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-1
MLRS ATTACHMENT REPLACEMENT - CONTINUED
0188 00
INSTALLATION - CONTINUED
10.
Install boom electrical cable (3) and connect electrical
55 54
56
leads (1) at electrical junction box (2).
53
57
11.
Loosen four screws (4) and separate cover (5) from
58
box (2).
71
12.
Carefully position cable (3) through hole in box (2).
6
02
CAUTION
7
52
Connect electrical leads to auto leveler cir-
51
cuit board as described in steps 13 thru 15.
Failure to follow instructions in these steps
may result in damage to circuit board.
13.
Connect electrical lead 50 to terminal VS of auto lev-
eler circuit board (9). Tighten screw on strip (8) to
3
secure lead 50.
10
2
14.
Connect electrical lead 65 to terminal A of auto lev-
eler circuit board (9). Tighten screw on strip (8) to
secure lead 65.
1
15.
Connect electrical lead 64 to terminal B of auto leveler
circuit board (9). Tighten screw on strip (8) to secure
lead 64.
5
NOTE
4
Terminals on (6) and (7) are not marked.
Refer to tags on terminal screws when
installing electrical leads to terminal strips.
16.
Connect electrical leads 51 and 52 (1) at bottom termi-
nal strip (7) of box (2). Tighten screws on strip to
9
secure leads.
17.
Connect electrical lead 02 at bottom terminal strip (6)
GND A B
VS
of box (2). Tighten screw on strip to secure lead 02.
8
18.
Connect electrical leads 58, 57, 56, 55, 54, 53 and 71,
50
at top terminal strip (6) of box (2). Tighten screws on
strip (6) to secure leads.
64
65
19.
Attach two new tie down straps (10) where cable (3)
enters box (2).
409-716
20.
Position cover (5) on box (2) and tighten four screws
(4).
0188 00-8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals