 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-1
MLRS ATTACHMENT REPLACEMENT - CONTINUED
0188 00
REMOVAL - CONTINUED
30
16.
Remove locknut (29), capscrew (30), pivot pin (31)
and two spacer rings (32), securing attachment (16) to
32
boom. Discard locknut.
NOTE
31
Spacer rings are used as required and may
29
not be present on all vehicles.
17.
Connect battery cables (WP 0107 00).
16
18.
Start engine (TM 10-3930-660-10) and carefully move
vehicle rearward to separate MLRS attachment (16)
from boom. Stop engine (TM 10-3930-660-10).
409-4041
19.
Place attachment (16) on suitable supports and remove lifting device.
INSTALLATION
WARNING
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death.
Be certain that metal caps are installed on fittings at front of boom as instructed in step 14 of Removal.
Failure to do so could result in personal injury caused by pressurized hydraulic oil spraying out of open
fittings when engine is started.
Support rear of cylinder with chain prior to installing MLRS attachment. Failure to do so may cause
personal injury and damage to cylinder.
NOTE
MLRS attachment weighs approximately 2,500 lb (1134 kg) when all components, including forks, remain
installed.
1.
Attach lifting device to attachment (16) and raise attachment to height required to align mounting holes of attachment
with holes in boom.
2.
Start engine (TM 10-3930-660-10) and carefully move vehicle toward MLRS attachment (16). Stop engine when
mounting holes are aligned. Stop engine (TM 10-3930-660-10).
0188 00-5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals