Click here to make tpub.com your Home Page

Page Title: INSTALLATION
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 10-3930-660-24-1
CONSOLE-MOUNTED RELAYS MAINTENANCE - CONTINUED
0083 00
REMOVAL - CONTINUED
3.
Remove two nuts (7), two lockwashers (8) and two screws (9) securing relay (6) to vehicle. Remove relay from vehicle.
Discard lockwashers.
INSTALLATION
NOTE
Apply loctite to screws as installed.
1.
Position relay (6) on vehicle and secure with two
9
6
screws (9), two new lockwashers (8) and two nuts (7).
1
8
409-322
7
2.
Connect electrical leads (5) to terminals of relay (6) and secure with six new lockwashers (4) and six nuts (3).
3.
Secure access panel (2) with four capscrews (1).
4.
Connect battery cables (WP 0107 00).
TESTING
NOTE
E
F
Testing procedures for all relays covered in
this work package are essentially similar.
A
Terminals (A thru D) are present on all relays
tested in this section. Terminals (E and F)
appear only on the two blackout headlight
B
relays.
Disconnect electrical leads from relay as
C
described in Removal.
D
409-323
1.
To test relay for proper solenoid operation, apply 24
volts DC to terminals (B and C).
2.
Listen for "click" when voltage is applied. If no "click" is heard, relay is defective and must be replaced. Refer to
Removal and Installation.
3.
To test relay for continuity, apply 24 volts DC to terminals (B and C).
4.
Ohmmeter should indicate continuity across terminals (A and D).
0083 00-3

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business