 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-660-24-1
ACCELERATOR PEDAL ASSEMBLY MAINTENANCE - CONTINUED
0050 00
ASSEMBLY - CONTINUED
3.
Secure pedal (23) to pedal base (28) with pivot pin (30) and spring clip (29).
4.
Install pushrod (12) to block assembly (22).
5.
Secure block assembly (22) and pushrod (12) to pedal (23) with long pin (21) and two spring clips (20).
6.
Secure hanger plate assembly (9) to pedal base (28) with U-bolt (26), bracket (27), new lockwasher (25) and nut (24).
7.
Install new bearing (19), spring (18), lever assembly (13), new bearing (17) and circlip (16) on shaft of hanger plate
assembly (9).
8.
Secure travel stop (15) to lever assembly (13) with capscrew (14).
9.
Secure pushrod (12) to lever assembly (13) with short pin (10) and spring clip (11).
10.
Secure cable support bracket (8) to hanger plate assembly (9) with screw (5), flatwasher (6) and nut (7).
INSTALLATION
1.
Position accelerator pedal assembly (4) on cab.
NOTE
4
Apply loctite to threads of capscrews. Have an
assistant retain capscrews inside cab while nuts
3
are installed.
2.
Secure accelerator pedal assembly (4) to cab with
three capscrews (3), three new lockwashers (2), and
three nuts (1).
3.
Connect accelerator cable to accelerator pedal (4) (WP
2
1
409-211
4.
Loosen jamnut (32) and turn capscrew (33) on accelerator pedal assembly (4) fully clockwise.
5.
Depress accelerator pedal to the end of its travel and hold. Turn capscrew (33) counterclockwise until head of capscrew
touches pedal.
6.
Release accelerator pedal and tighten jamnut (32).
7.
Use STE/ICE-R to check engine rpm at full throttle (WP 0008 00). If necessary, readjust capscrew (33), as required,
until engine full throttle rpm is within limits.
END OF WORK PACKAGE
0050 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals