GENERAL PMCS PROCEDURES - CONTINUED - TM-10-3930-660-24-10173

TM 10-3930-660-24-1

NOTES

LUBRICATION. During adverse weather or abnormal dusty conditions, lubrication may require daily servicing.

The lubricating points for the brake pedal and transmission disconnect pedal counter shaft are located under the cab

(GAA).

Lubricate all hinges and door latches with a hand oiler (OE/HDO).

Check the differential oil levels while vehicle is on a level surface. Oil should be to the bottom of the check and fill hole

(GO).

Lubricate after fording operations (GAA).

WARNING - Do not stand under the attachment and carriage assembly during lubrication services. To lube the

carriage lube points and tilt cylinder lower points, raise the fork assembly 48 in. (122 cm) and tilt the carriage assembly

forward 90 degrees. To lube the tilt cylinder's head pivot pin, place the level forks/carriage firmly on the ground (GAA).

During adverse weather, dusty or sandy conditions, change transmission oil and filter element at 250-hour intervals. For

normal off-highway operation, for operation under rapid change in ambient temperature, or for operation in presence of

chemical fumes, change at 375-hour intervals. Use MIL-L-2104D hydraulic transmission fluid when operating the vehi-

cle in temperatures above -10 F (-23C), and MIL-L-46167A transmission fluid when operating in temperatures below -

10F (-23C).

To lube the steering knuckle joint, the vehicle may have to be moved forward or backward to align grease fitting with

access hole. If the fitting is aligned with the access hole but grease gun will not go on fitting, turn the wheels right or left

until grease gun fits on grease fitting (GAA).

Raise the boom to approximately 15 inches (38 cm) to lubricate the boom hoist cylinder pins (GAA).

10.

Drain hydraulic reservoir every 2,000 hours. Change hydraulic oil filter and add oil (OE/HDO) to reservoir until oil is

visible in sight gauge. Operate hydraulic system and check oil level again.

0010 00-9