TM10-3930-660-20 2-13. STE/ICE VEHICLE SYSTEM DIAGNOSTIC CHECK a. General. This section contains information and tests which may be used with STE/ICE (Simplified Test Equipment for Internal Combustion Engines) to locate malfunctions that may occur in the vehicle. The tests can be used during troubleshooting, corrective maintenance, and after routine adjustments. The STE/ICE system is primarily used in conjunction with the vehicle electrical system. The test cannot cover all possible malfunctions that may occur. If a particular malfunction is not discussed, refer to the troubleshooting tables. NOTE Refer to page 2-101 for a copy of the vehicle STE/ICE  test  card. b. Description  and  Operation.  STE/ICE is portable and operates off of the vehicles 24  volt  system. The STE/ICE kit consists of the following items: Refer to the figures below and on page 2-52. 0 Vehicle Test Meter (VTM) o Transducer Kit (TK) o Four Electrical Cables (Wl, W2, W3, and W4) o Transit Case o Technical Publications TABLE 2-4 STE/ICE KIT 1. Tray, Transducer Kit 2. Cable Assembly, power W1 3. Cable Assembly, Special W2 4. Shell, Electrical Connector 5. Shell, Electrical Connector 6. Clip, Electrical 7. Cable Assembly, Special W3 8. Shell, Electrical Connector 9. Clip, Electrical 10. Shell, Electrical Connector 11. Cable Assembly, Power W4 12. Cable Assembly, Power W5 13. Shell, Electrical Connector 14. Clip, Electrical 15. Shell, Electrical Connector 16. Case, Test Set 17. STE/ICE Test Meter 2-51