| |
TM10-3930-660-20
18-26.
HYDRAULIC HOSES, LINES AND FITTINGS - REPLACE/REPAIR (Contd)
INSTALLATION
CAUTION
If removed, tighten elbow (251) and
adapter (252) to 55 ft. lb. during
installation. Do not overtighten.
Failure to follow this instruction could
result in damage to transmission hose
ports.
Remove caps and plugs as hoses are
installed. Wipe all sealing surfaces on
hoses and components to which they
connect clean and dry. Apply a film of
clean hydraulic oil to all O-ring seals
on fittings as fittings are installed.
1.
2.
3.
4.
5.
INSTALL FITTINGS AND HOSE ASSEMBLIES
(1 THROUGH 242), AS APPLICABLE.
IF INSTALLING A FITTING EQUIPPED
WITH AN O-RING, FIRST APPLY CLEAN
HYDRAULIC OIL TO O-RING.
IF PREVIOUSLY DRAINED, REFILL
HYDRAULIC RESERVOIR TO PROPER LEVEL,
PARA. 5-10.
START ENGINE AND OPERATE ALL
HYDRAULIC SYSTEMS IN WHICH HOSE
ASSEMBLIES AND/OR FITTINGS HAVE BEEN
REPLACED. CHECK CAREFULLY FOR LEAKS.
CORRECT ANY LEAKS BY TIGHTENING
CONNECTION OR PART REPLACEMENT
BEFORE RESUMING VEHICLE OPERATION.
18-112
|