TM1O-393O-66O-2O 17-5. WINDSHIELD WASHER ASSEMBLY - SERVICE/REPLACE (Cont’d) REMOVAL 1. REMOVE RESERVOIR ASSEMBLY (2) FROM SIDE CONSOLE (3). TO prevent spillage of washer fluid, be sure reservoir assembly (2) is emptied of fluid before removal. a. Tag and disconnect female spade connector of electrical lead (4) from male spade connector on resistor assembly (5). b. Remove capscrew (6), starwasher (7), electrical lead (8) and second starwasher (7) from side c. Support reservoir assembly (2) so it does not drop when screws (10) and lockwashers (11) are removed. d. 2. IF ASSEMBLY (5) FROM SIDE CONSOLE (3). Remove four screws (10), four lockwashers (11), and reservoir assembly (2) from side console (3).  Discard  lockwashers  (11). NECESSARY,  REMOVE  RESISTOR a. Tag and disconnect female spade connector of electrical lead (12) from male spade connector on resistor assembly (5). 17-11